Supplemental instructions for the Hanna Instruments HI 98121 pH/ORP tester in water ionizer applications, covering cleaning, ORP pretreatment and storage.
This supplemental instructional manual from Hanna Instruments covers use of the HI 98121 portable pH and ORP tester for water ionizer applications. It answers frequent questions about why the tester may stop reading high negative mV ORP values and how often the pH/ORP sensor should be cleaned in HI 7061 cleaning solution.
The manual explains the pH scale from 0 to 14 and the meaning of ORP in millivolts, then describes ORP preparation and measurement, including pretreatment with HI 7091M or HI 7092M solutions and a pH/mV reference table. Maintenance, cleaning, polishing of the platinum sensor and storage with HI 70300M storage solution are also described, along with the solutions contained in the ionizer solutions kit.
| Measured parameters | pH and ORP |
|---|---|
| Form factor | Portable tester |
Mineral buildup on the surface of the platinum ORP sensor interferes with the full -mV scale. Try cleaning the sensor in HI7061 cleaning solution for 15 minutes.
Clean the pH/ORP sensor after each use by soaking it in HI7061 cleaning solution for 2-3 minutes.
Soak the platinum surface in pretreatment solution for 15 minutes to get a faster response time.
Keep the tip and junction moist by replacing the protective cap with a few drops of HI 70300M storage solution, and never store the electrode in distilled or deionized water.