Installation guide for the FASTrack ALU drainage system, covering tools, parts, assembly steps, drainage fittings, and leveling.
The FASTrack ALU Drainage Assembly Guide explains how to plan and install the aluminum FASTrack drainage system. It lists required tools and parts, describes track bridge and track clip assembly, and covers preparation of SST 304 drainage fittings and black polypropylene 90° elbow fittings.
The guide gives assembly steps for cutting track to length, drilling and tapping drainage ports, leveling track bridges, inserting tracks and clips, installing drain channel infill and end plugs, and attaching drainage hoses. It also includes examples for typical drainage tubing, corner installation, and system drainage.
| Trench depth | 65 mm (2 9/16 in) |
|---|---|
| Minimum track spacing | 2.25 in (57.15 mm) |
| Maximum assembly slope | Up to 2° |
| Recommended track bridge spacing | 12 to 24 in |
| Maximum distance between hose fittings | 30 in |
| Drainage port thread | 1/4 in NPT |
| Drainage tubing slope | 1/4 to 1/2 in per foot |
| Trench width | Track width + 3 in |
Yes. The guide states that the FASTrack Drainage System can be assembled to slope up to 2° for surface drainage.
The guide recommends 12 to 24 inches between Track Bridges, with 12 inches for maximum adjustability and up to 24 inches for basic installations.
The drainage port is threaded to 1/4 in NPT.
No. The guide says not to mix and match parts between the FFI Stainless Steel FASTrack system and Aluminum FASTrack system because they will not be compatible.