Installation instructions for lip seals on Dodge Type K, DOUBLE-INTERLOCK, TAF, Type E, and Type C bearings, including location diagrams and shaft size tables.
This guide provides installation procedures for lip seals used on Dodge Type K, DOUBLE-INTERLOCK, TAF, Type E, and Type C bearings. It specifies that these seals are press-fitted into the inside diameter of the housings and must be installed using cylindrical sleeves or plungers with square faces to ensure proper alignment against the face of the cone.
The document includes detailed diagrams showing seal locations for various shaft sizes and provides specific dimensional tables for Type K, Type E/TAF/DOUBLE-INTERLOCK, and Type C bearings. It emphasizes the importance of using qualified personnel and following safety codes during installation.
| Applicable Bearing Types | Type K, DOUBLE-INTERLOCK, TAF, Type E, Type C |
|---|---|
| Seal Mounting Method | Press fitted on the inside diameter of the housings |
| Required Tooling | Cylindrical sleeves or plungers with square faces |
Lip seals must be press fitted on the inside diameter of the housings using cylindrical sleeves or plungers with square faces.
The cylindrical sleeves or plungers must have shoulders that bottom against the face of the cone to control location.