This manual describes the features and usage of the Dodge cooling lubrication system.
This Chinese-language manual from Baldor Electric Company covers the Dodge cooling lubrication system in part numbers 055860, 058530, 067669, 067912 and 068862. It starts with safety warnings and system parameters (supply voltage, operating temperature, pump and bearing relief valve settings, design flow rates), then walks through receiving and inspection, installation, piping and electrical connection, and step-by-step operating instructions for filling the pump, checking flow and balancing oil to the bearings.
A maintenance section covers filter replacement, oil level checks and routine upkeep, followed by dimensioned drawings and piping schematics for the single-phase and three-phase units, a parts list including the spare filter part number 056728, and the Baldor/Dodge contact addresses. The instructions state that the manual must be read before installation or operation. This manual is written in Chinese.
| Supply voltage (part numbers 055860, 058530, 067912) | 120 V, single phase, 60 Hz |
|---|---|
| Supply voltage (part numbers 067669, 068862) | 460 V, three phase, 60 Hz |
| Operating temperature | 32.22 °C - 54.44 °C |
| Pump relief valve setting (field adjustable) | 10.3 psi |
| Bearing relief valve setting (field adjustable) | 4.5 psi |
| Maximum system pressure | 10.34 psi |
| Design flow rate (all except 068862) | 1.9 LPM |
| Design flow rate (068862) | 3.8 LPM |
| Tank oil fill (055860) | 7.6 gallons |
| Tank oil fill (058530, 067669, 067912, 068862) | 11.4 gallons |
| Factory preset bearing flow (068862) | 1.51 LPM |
| Motor (drawing 058530-1) | 1/2 HP single phase 115 VAC, 1725 RPM |
| Spare filter part number | 056728 |
Part numbers 055860, 058530 and 067912 use 120 V single-phase 60 Hz motors, while 067669 and 068862 use 460 V three-phase 60 Hz motors. Where fitted, the heaters and switches are 120 V single phase 60 Hz.
Fill the 055860 with 7.6 gallons of clean oil, and the 058530, 067669, 067912 and 068862 with 11.4 gallons. Refit and tighten the fill cap afterwards.
The filter should be checked and cleaned of dirt, and replaced after the first 10 hours of operation, then as needed.
The oil level should be monitored continuously, checked closely during the first few hours, and then every 100 hours.