User manual for the Comica LINKFLEX-AD1 XLR interface preamp audio adapter for cameras and smartphones, covering setup, gain adjustment and real-time…
This manual covers the Comica LinkFlex LINKFLEX-AD1, an XLR interface preamp audio adapter that connects an XLR microphone to a smartphone or camera for audio recording. It supports all XLR dynamic and positive condenser microphones (not passive condenser mics needing external phantom power) and is compatible with iOS and Android systems; an original 3.5mm-to-Lightning adapter is required for iPhone 7 and newer Lightning iPhones.
The guide describes the package contents and components (XLR input jack, 3.5mm output, monitoring jack, gain control wheel, power/camera/smartphone switch, back clip and LED indicators), installation steps for camera and smartphone use, and technical parameters such as +10dB maximum gain, 20Hz-20kHz frequency response and CR2032 3V battery power.
| Output | 3-pin XLR interface |
|---|---|
| Input | 3.5mm connector |
| Gain adjustment | Maximum increase +10dB |
| Frequency response | 20Hz - 20kHz ±1dB |
| Total harmonic distortion + noise | <0.02%, RL=2kΩ, f=20~20KHz, Vo=0.7Vrms |
| Battery | CR2032 3V |
It supports all XLR dynamic and positive condenser microphones, but not passive condenser microphones that need external phantom power.
Yes, but the original audio cable adapter (3.5mm-Lightning) is needed for those iPhones.
No, on Android it only supports the phone's original audio recording mode, not video mode; a third-party app is needed for video shooting.
When the battery is low the indicator light turns red, and a new battery should be installed.