Cisco ASA FirePOWER Module Quick Start Guide

About this manual

This guide provides step‑by‑step instructions for initial configuration, management access, software installation, and integration with the FireSIGHT Management Center. It covers both inline deployment, where traffic passes through the module, and passive (monitor‑only) deployment, where only a copy of traffic is sent.

The document also details supported ASA platforms, required software versions, hardware versus software module differences, and procedures for changing management IP addresses, configuring security policies, and redirecting traffic.

What's inside

• ASA FirePOWER Module Overview
• Deployment Modes (Inline and Passive)
• Management Access Methods
• Initial Configuration via CLI
• Software Installation and Re‑imaging
• Changing Management IP Address
• Adding the Module to FireSIGHT Management Center
• Configuring Security Policies
• Redirecting Traffic to the Module
• Additional Information and References

Specifications

Frequently asked questions

What is the minimum software version required for the ASA FirePOWER module?

The module requires ASA software 9.2 (2.4) and ASA FirePOWER version 5.3.1.

Which ASA model uses a hardware FirePOWER module?

Only the ASA 5585‑X model uses a hardware FirePOWER module; all other listed models use a software module.