Bently Nevada 370300 accelerometer transducer datasheet: 100 mV/g sensitivity, 80 g peak range, 6,000 V isolation, specifications and ordering options.
This datasheet (115M8762 Rev. B) describes the Bently Nevada 370300 accelerometer transducer, which provides high electrical isolation between the base of the transducer and its internal electronics, giving protection against arcing and electrostatic discharge up to 6,000 volts. The transducer has an amplitude range of 80 g peak and a sensitivity of 100 mV/g, and is intended for machine condition monitoring where rotor vibration is transmitted to the bearing housing or machine casing at the mounting location.
The document gives detailed specifications, including frequency response, resonance frequency, temperature range, power requirements, shock limits and physical data. It also explains that care must be taken during physical installation, since improper installation can degrade performance or generate signals that do not represent actual machine vibration, and that integration of the output to velocity can increase degradation — the 330500 Velomitor sensor is recommended for high quality velocity measurements. Ordering information covers mounting thread and agency approval options, the 02173034 interconnect cable and the 115M8763 user guide.
| Sensitivity | 10.2 mV/m/s2 (100 mV/g) ±5% at 25 °C |
|---|---|
| Acceleration Range | 80 g peak (784 m/s2) |
| Frequency Response | 3 - 5 kHz (180 - 300,000 CPM) ±5%; 1 - 7 kHz (60 - 420,000 CPM) ±10%; 0.5 - 12 kHz (30 - 720,000 CPM) ±3 dB |
| Resonance Frequency | 25 kHz (1,500 kCPM) |
| Transverse Sensitivity | 5% of axial, max |
| Temperature Range | -40 to +248 °F (-40 to +120 °C) |
| Dielectric Withstand Voltage | 6,000 VDC 1 min; 5,000 VAC 1 min between connector and surface |
| Excitation Voltage | +24 Vdc nominal, 18 to 30 Vdc regulated |
| Current Range | 3 mA nominal, 2 to 10 mA |
| Output Bias Voltage | +12 VDC nominal |
| Shock Survivability | 49,050 m/s2 (5000 g) peak, maximum |
| Weight (no cable) | 4.35 oz (122 g) |
| Diameter | 2.54 in (64.4 mm), including mounting stud |
| Height | 2.3 in (59 mm), including mounting stud |
| Connector | 2-pin MIL-5015 receptacle |
| Case Material | 303 stainless steel |
Its sensitivity is 10.2 mV/m/s2 (100 mV/g) ±5% at 25 °C.
It isolates the transducer base from its internal electronics, offering protection against arcing and ESD as high as 6,000 volts.
The ordering options are M8 x 1.25, ¼-28 UNF and M6 x 1.0 integral mounting.
Cable 02173034, a 2-conductor MIL-C-5015 shielded 22AWG cable with a splash-proof boot, 32 ft/10 m long.