Dell 10Gb Ethernet Pass Through II for M1000e Software User's Manual

The Dell 10Gb Ethernet Pass Through II is a high-performance network adapter designed specifically for Dell M1000e blade servers. It supports 10GbE speeds and includes a number of advanced features such as virtualization support, traffic management, and failover.


Dell 10Gb Ethernet Pass Through II for M1000e Software User's Manual - cover page
Brand
DELL
Category
Other network devices
Document type
User Manual
Language
English
Pages
26
File format
PDF
File size
1.1 MB
Published
26 November, 2023
Updated
26 November, 2023
MD5 checksum
E6FDD904A1787EFA5CEE3698C810C281

About this manual

This software user's manual describes installation and basic use of the Dell 10Gb Ethernet Pass Through II for M1000e. It is intended for users and system administrators responsible for installing and setting up the I/O module.

The manual explains how to connect to the 10GbE PTM and CMC, use the CLI, and update module and device software and firmware. It also covers port groups, LED behavior, status lights, and troubleshooting.

What's inside

  • Overview
  • Port Groups
  • Port Link State Reflection
  • Link Protocol Mismatch Condition
  • LED Behavior
  • 10GbE PTM Status Lights
  • Connecting to the 10GbE PTM CLI
  • Command Line Interface (CLI) Reference
  • Operating Procedures
  • Troubleshooting

Specifications

Front panel ports16, divided into two groups (A and B)
Group APorts 1 through 8, serving blades 1 through 8
Group BPorts 9 through 16, serving blades 9 through 16
Supported link protocol10GigE XAUI (KX4)
PhyX component numberingComponents 1 to 3; device 0 is the on-board micro-controller

Frequently asked questions

How many front panel ports does the 10GbE PTM have?

It has 16 front panel ports, divided into Group A (ports 1 through 8) and Group B (ports 9 through 16).

What link protocol is supported on all ports?

The supported link protocol for all ports is 10GigE XAUI (KX4).

How do I connect to the 10GbE PTM CLI over a network?

Use an SSH client that supports ZModem file transfer; if you connect directly to the CMC serial port, the manual says to skip to step 9.

What should be done after updating the 10GbE PTM firmware?

Power cycle the 10GbE PTM so the firmware takes effect.

Download PDF (1.1 MB)

More DELL Manuals


View all DELL manuals →