Dell PowerEdge 2550 System Installation and Troubleshooting Guide

The Dell™ PowerEdge™ 2550 Systems Installation and Troubleshooting Guide describes how to install and troubleshoot the Dell™ PowerEdge™ 2550 system.


Dell PowerEdge 2550 System Installation and Troubleshooting Guide - cover page
Brand
DELL
Category
Servers Computer
Document type
Service Manual
Language
English
Pages
81
File format
PDF
File size
1.9 MB
Published
26 November, 2023
Updated
26 November, 2023
MD5 checksum
ABD7BC96FD704F283B0587957BF58110

About this manual

This Dell PowerEdge 2550 Systems Installation and Troubleshooting Guide covers the introduction, checking basics, messages and codes, finding software solutions, running Dell Diagnostics, checking equipment and the system interior, installing system board options and drives, getting help, and jumper, switch, and connector reference.

The hard-disk drive section describes installing and configuring SCSI drives in the internal bays, which provide space for up to four 1-inch drives; a fifth drive can be installed in the peripheral bay using an upgrade kit. It also covers the 1 x 4 and optional split 2 x 2 backplane configurations, Dell PERC host adapter installation, the SCSI backplane daughter card, and selecting the boot device with System Setup.

What's inside

  • Introduction
  • Checking the Basics
  • Messages and Codes
  • Finding Software Solutions
  • Running the Dell Diagnostics
  • Checking the Equipment
  • Checking Inside the System
  • Installing System Board Options
  • Installing Hard-Disk Drives
  • Jumpers, Switches, and Connectors

Specifications

Hard-disk drive capacityUp to four 1-inch hard-disk drives in the internal bays
SCSI drive terminationDisabled on the drives
SCSI bus terminationProvided by the SCSI backplane board
SCSI ID assignmentSet by the SCSI backplane board
Backplane configuration1 x 4, with optional split 2 x 2 mode
Hot-plug supportNot supported without an integrated RAID controller or Dell PERC host adapter card

Frequently asked questions

How many hard-disk drives can the system hold?

The internal hard-disk drive bays hold up to four 1-inch drives; a fifth can be installed in the peripheral bay with an upgrade kit.

What should be done with SCSI termination on the drives?

Termination on the drives should be disabled; the SCSI backplane board provides termination for the SCSI bus.

Is hot-plug drive installation supported?

It is not supported for systems without an integrated RAID controller or Dell PERC host adapter card.

How do you choose the boot controller?

Select the primary controller using the System Setup program.

Download PDF (1.9 MB)

More DELL Manuals


View all DELL manuals →