Dell EMC OpenManage Ansible Modules allow data center and IT administrators to manage Dell EMC systems using Redfish and WS-Man protocols.
This Dell EMC installation guide covers Dell EMC OpenManage Ansible Modules version 2.0.1, a set of modules that lets data center and IT administrators use RedHat Ansible to automate the configuration, deployment, and update of Dell EMC PowerEdge Servers (12th generation and later) and modular infrastructure through iDRAC and OpenManage Enterprise. It describes the prerequisites and the support matrix for control machines and managed nodes.
The guide then gives step-by-step instructions for installing version 2.0.1 either from the Dell support site or from the GitHub repository, including cloning the devel branch, the master branch, or the v2.0.1 release, and for uninstalling the modules depending on where they were downloaded from.
| Ansible version | 2.7.5 or later |
|---|---|
| Python version | 2.7.5 and later |
| Supported operating system (control machine) | Red Hat Enterprise Linux (RHEL) 7.6, SLES 15 |
| Supported firmware, 12th and 13th generation PowerEdge servers | 2.60.60.60 and above |
| Supported firmware, 14th generation PowerEdge servers | 3.21.21.21 and above |
You must install Ansible version 2.7.5 or later and Python version 2.7.5 or later. For the iDRAC modules, the supported version of OpenManage Python Software Development Kit (OMSDK) is also required.
Download the DellEMC_OpenManage_Ansible_Modules_version_2.0.1.273_A00.tar.gz file, extract it, navigate to the extracted directory, and run python install.py (or python3 install.py for Python 3.x).
Clone the release branch, for example git clone -b v2.0.1 --single-branch, change into the dellemc-openmanage-ansible-modules directory, and run python install.py.
Navigate to the directory where the modules were downloaded and run python uninstall.py, or python3 uninstall.py if you are using Python version 3.x.