Dell™ Systems Microprocessor Upgrade Installation Guide
This Dell Systems Microprocessor Upgrade Installation Guide (P/N 9D904, Rev. A05, March 2003) explains how to add a secondary microprocessor or replace an existing one in a Dell system. It opens with notes, notices and cautions, then describes the microprocessor and its cache memory in a pin-grid array (PGA) package installed in a ZIF socket on the system board, and lists the contents of the microprocessor upgrade kit.
The procedure walks through checking and updating the system BIOS, removing the cooling shroud and heat sink, lifting the old microprocessor out of the socket, aligning pin 1 and seating the new microprocessor, refitting the heat sink and cooling fan, and installing VRMs for a secondary microprocessor. It ends with reconnecting the system, entering the System Setup program to confirm the new configuration, and running system diagnostics.
| Microprocessor package and socket | Microprocessor and cache memory in a pin-grid array (PGA) package installed in a ZIF socket on the system board |
|---|---|
| Secondary microprocessor speed | Must be the same speed as the primary microprocessor |
| VRM matching | The system does not support mismatched VRMs |
| Upgrade kit contents | A microprocessor, a heat sink, heat-sink retention clip(s) and a VRM if applicable; a cooling fan may also be included |
Check the latest system BIOS information on the Dell Support website at support.dell.com and upgrade the BIOS if necessary.
Yes. The secondary microprocessors must be the same speed as the primary microprocessor.
No. Because the system uses a ZIF microprocessor socket, the microprocessor should drop down into the socket with minimal pressure when positioned correctly.
Enter the System Setup program and make sure the microprocessor categories match the new system configuration, then run the system diagnostics.