HiVi Microphone Effects Processor Integrated Machine Product Manual
This is the Chinese product manual for the HiVi DSP-10 audio processor with microphone, described in the document as a microphone effects processor integrated machine (惠威话筒效果处理器一体机). It covers the important safety notices, the function of each key and control on the front panel, and the input and output connectors on the rear panel, including MIC A1/B1, VOD, AUX, BGM, COAXIAL and OPTICAL inputs and the main, center, sub and surround outputs.
The manual then explains the effect processor key menus for music and microphone parameters such as EQ, noise gate, feedback suppressor, limiter, reverb and echo, gives the unit's performance specifications and the wireless microphone specifications, describes channel group setting and IR synchronization between receiver and transmitter, offers advice on antenna placement, and closes with simple troubleshooting tables and a hazardous-substances table. This manual is written in Chinese.
| Music maximum input level / maximum output level | 4.5V(RMS) / 4.5V(RMS) |
|---|---|
| Music channel gain | MAX: 18dB |
| Wired microphone sensitivity | 20mV (OUTPUT: 1.9V) |
| Signal-to-noise ratio | >80dB |
| Input power voltage | ~220V 50Hz |
| Dimensions | 482x227x49 |
| Net weight (main unit / microphone) | Main unit 3.15 Kg; microphone 0.4 Kg each |
| Wireless microphone frequency range | 686-790MHz |
| Number of channels | 351 channels, left and right the same |
| Operating distance | about 30-80 m (depends on surroundings) |
| Audio frequency response | 50Hz-16KHz (circuit section) |
| System signal-to-noise ratio | >90dB (A-weighted, at maximum output) |
| Microphone capsule type / pickup pattern | Dynamic; cardioid |
Bring the transmitter's sync point about 3-10 cm from the receiver's sync lamp and hold it there until the lamp goes out.
Up to 12 units (24 channels) in an ideal environment; generally four or fewer are recommended to reduce interference.
Each channel has 8 groups (C43-C50) and each group has 27 channels (001-027).
The unit is specified for ~220V 50Hz input power; check that the local mains matches before connecting.