This manual provides OEM product information for SanDisk microSD™, microSDHC™ and microSDXC™ cards, including product specifications, technical data and design recommendations.
The SanDisk microSD, microSDHC and microSDXC OEM Product Manual, Revision 2.6 dated July 2012, describes flash-based removable non-volatile memory cards designed for mobile phones and consumer electronic devices. The cards are based on the SD Card specification and provide up to 64 GB of storage using flash memory chips with an on-board intelligent controller.
The manual covers product specifications, the 8-pin interface, SD Bus and SPI Bus operation, registers, protocol, marking and ordering information. It lists a 2.7 to 3.6V voltage range, a maximum operating frequency of 100 MHz and data transfer rates up to 50 MB/sec using four parallel data lines.
| Data storage capacity | Up to 64 GB |
|---|---|
| Voltage range | 2.7 to 3.6V |
| Host interface | SD Bus and SPI Bus |
| Maximum operating frequency | 100 MHz |
| Data transfer rate | Up to 50 MB/sec using four parallel data lines |
| SD Card standard compatibility | SDA Physical Layer Specification, Version 3.01 |
The SanDisk microSD Card Product Family provides up to 64 GB of data storage using flash memory chips.
The cards operate over a voltage range of 2.7 to 3.6V.
Yes. The manual lists SPI Mode support and an alternate communication protocol based on the SPI standard.
The cards are based on an 8-pin interface designed to operate at a maximum operating frequency of 100 MHz.