ST AN4192 Power MOSFETs Best Choice Guide for VRM Applications Application Note

This document presents the best choice guide for ST power MOSFETs in VRM applications.


ST AN4192 Power MOSFETs Best Choice Guide for VRM Applications Application Note - cover page
Brand
S&T
Category
MOSFET
Document type
Application Note
Language
English
Pages
47
File format
PDF
File size
4.8 MB
Published
02 November, 2023
Updated
02 November, 2023
MD5 checksum
C479A936BBB8DAA78D4BD093DE434EB5

About this manual

ST application note AN4192 (Doc ID 023820 Rev 1, November 2012) by Filadelfo Fusillo and Filippo Scrimizzi discusses power MOSFET selection for voltage regulator modules used with modern desktop and notebook CPUs. It describes the multiphase synchronous buck converter topology and the need to deliver low core voltage at high current and switching frequency.

The document examines high-side and low-side MOSFET selection. Topics include QG,SW and fSW effects on efficiency, RDS(on) and conduction loss minimization, gate drive network optimization, CGD (Miller capacitance), LS body-drain diode Qrr, RG and LS gate-source bouncing, RC snubber settings, and the phase node spike to VCORE relationship.

What's inside

  • Synchronous buck converter: a brief introduction
  • High-side MOSFET selection
  • QG,SW and fSW impact on the efficiency
  • RDS(on) and conduction losses minimization
  • Gate drive network optimization
  • Low-side FET selection
  • CGD (Miller capacitance)
  • LS body-drain diode Qrr (reverse recovery charge)
  • RG and LS gate-source bouncing
  • RC snubber network settings

Specifications

Typical core voltage1.2 V - 1.3 V
Output currentup to 160 A
Switching frequencyup to 500 - 700 kHz
Typical input voltage12 V
Per-phase currentup to 25 - 30 A

Frequently asked questions

What converter topology does the application note describe for VRMs?

It describes the multiphase synchronous buck converter, which steps down the 12 V input voltage to the desired core voltage.

How are cross-conduction and shoot-through avoided?

The control IC drives the high-side and low-side FETs synchronously and provides deadtime intervals so they do not conduct at the same time.

Why is the multiphase approach used?

The document says each phase can manage up to 25 - 30 A, so the multiphase approach can handle high currents with improved efficiency.

What is QG,SW also called?

The charge amount QG,SW is also called the switching charge.

Download PDF (4.8 MB)

More S&T Manuals


View all S&T manuals →