PULSAR® HYDRAULIC DIAPHRAGM METERING PUMPS Bulletin: IOM-PSR-1500-Rev.G Installation, Operation & Maintenance Manual

This manual introduces the operation and maintenance of the PULSAR® series hydraulic diaphragm metering pumps.


PULSAR® HYDRAULIC DIAPHRAGM METERING PUMPS Bulletin: IOM-PSR-1500-Rev.G Installation, Operation & Maintenance Manual - cover page
Brand
Pulsafeeder
Category
Other
Document type
User Manual
Language
English
Pages
54
File format
PDF
File size
2 MB
Published
31 October, 2023
Updated
31 October, 2023
MD5 checksum
35C3731B7E0773872260845C05FB822E

About this manual

The PULSAR is a positive displacement reciprocating metering pump from Pulsafeeder. A piston displaces hydraulic oil, and a hydraulically operated diaphragm separates the oil from the process liquid. Suction and discharge check valves control product flow, and the pump is driven by a standard C-face electric motor through worm gears.

This Installation, Operation & Maintenance manual covers general description and principles of operation, inspection and storage, installation and piping, equipment setup and lubrication, startup and priming, maintenance procedures, replacement parts, and troubleshooting. Appendices cover PULSAlarm leak detection, piping calculations, oil specifications, bolt torque recommendations, and Pulsafeeder accessories.

What's inside

  • Introduction and General Description
  • Principles of Operation
  • Equipment Inspection and Storage Instructions
  • Installation and Piping System
  • Equipment Setup and Lubrication
  • Startup Procedure and Priming
  • Maintenance and Oil Changes
  • Wet End Removal, Inspection, and Reinstallation
  • Troubleshooting Chart
  • PULSAlarm Leak Detection System

Specifications

Pump typePositive displacement reciprocating pump
Sealing methodHydraulically operated diaphragm separates hydraulic oil from product
Stroke length adjustment scale0–100 scale on top of the unit
Control cover bolt torque20–24 in-lbs (225–270 N-cm)
Motor typeStandard C-face electric motor

Frequently asked questions

What does the piston in a PULSAR pump move?

It moves hydraulic oil, not the chemical product being pumped.

How is the stroke length changed?

By depressing and turning the hand knob; the setting is shown on a 0–100 scale on top of the unit.

What torque should be used for the control cover bolts?

Tighten them to 20–24 in-lbs (225–270 N-cm).

What is the function of the PTP valve?

It automatically removes gases from the hydraulic system during normal operation.

Download PDF (2 MB)

More Pulsafeeder Manuals


View all Pulsafeeder manuals →