This manual describes the function and use of the ELGS-TB gear belt unit.
This Chinese-language operating manual covers the Festo ELGS-TB toothed belt axis unit (document 8174306, edition 2022-04c). It is a translation of the original operating instructions and lists related documents for the integrated EMCS-ST motor, ELGC-TB belt axis, EAMM-A axial mounting kit and NEFC adapter.
The document describes intended use, product configuration and interfaces, then gives instructions for transport, assembly, electrical installation and commissioning in DIO and IO-Link modes. It also covers operation, including control priority, the metric reference system, restart and referencing. This manual is written in Chinese.
| Firmware version | From v19.0.4.107_release |
|---|---|
| IO-Link input current at pin 1 (L+) | 100 ... 150 mA |
| Maximum support spacing during transport | ≤300 mm |
It is used to move workloads linearly or, with an external guide, as a drive between two end positions. It can be used in slide mode.
Use a PELV power supply with a low-voltage circuit that is reliably isolated from the mains, and observe IEC 60204-1/EN 60204-1.
Wait until initialization is complete and the C/Q LED lights yellow, which takes up to 7 seconds.
The EMCS-ST starts and displays a fault that must be acknowledged.