ST251/ST251R/ST277R Product Manual
This manual supports the Seagate ST251, ST251R and ST277R disc drives and replaces the earlier ST251 product manual. It provides specification summaries, access timing, physical and reliability data, mounting requirements and drive configuration options.
The manual also documents write fault latch options, DC-unsafe behavior, precompensation, life-test mode, auto-truncation and an appendix with an MFM/RLL format example.
| Rotational speed | 3,600 RPM ±0.5% |
|---|---|
| Recording density (ST251) | 9,935 BPI |
| Recording density (ST251R/ST277R) | 14,902 BPI |
| Flux density | 9,935 FCI |
| Track density | 777 TPI |
| Interface | ST412 |
| Recording method | MFM or RLL (2,7) |
| Data transfer rate (ST251) | 5.0 Mbits/sec. |
| Data transfer rate (ST251R/ST277R) | 7.5 Mbits/sec. |
| Height | 1.63 inch. max. (41.4 mm) |
| Width | 5.77 inch. max. (146.1 mm) |
| Depth | 8.00 inch. max. (203.2 mm) |
| Weight | 2.75 Ibs. (1.25 Kg.) |
| MTBF | 20,000 Power-on hours (Sea level, 25°C ambient temp.) |
| Recoverable read errors | 1 per 10^10 bits read |
| Nonrecoverable read errors | 1 per 10^12 bits read |
| Seek errors | 1 per 10^6 seeks |
| Bit jitter reduction | at least -40 dB at 2F |
| Bit jitter offset error | less than 1.5 nsec. |
| Media defect-free cylinders | Cylinders 0, 1, 2 and 3 |
| Maximum media defect length | up to 16 bits |
| Track-to-track seek time | 8 msec. max. |
| Average seek time | 40 msec. max. |
| Full-stroke seek time | 95 msec. max. |
| Step pulse period | 3 to 200 µsec. |
| Maximum data cylinder | 820 |
No, they do not require precompensation.
It occurs when excessive step pulses would place the heads beyond Track 0 or beyond the maximum data cylinder plus one; the drive then ignores additional pulses, takes control of the actuator and recalibrates to Track 0.
It can be cleared by deselecting the drive after the fault condition is corrected.
Yes, cylinders 0, 1, 2 and 3 are free of defects.