Jenco 6311 pH/ORP and Temperature Controller Operation Manual

This is an instruction manual that introduces the operation of the Jenco Model 6311 Microcomputer Based pH / ORP and Temperature Controller.


Jenco 6311 pH/ORP and Temperature Controller Operation Manual - cover page
Brand
JENCO
Category
Analyzer
Document type
User Manual
Language
English
Pages
36
File format
PDF
File size
834 KB
Published
26 October, 2023
Updated
26 October, 2023
MD5 checksum
7ECDF0EEFB99C5E866DA28342D04F95C

About this manual

The Jenco Model 6311 is a microprocessor-based pH/ORP and temperature controller housed in a watertight ¼ DIN case for laboratory and process control applications. It simultaneously displays pH or ORP, temperature, and relay status on a large LCD screen and performs self-diagnostics at power-up.

The controller features four programmable control relays with hysteresis, a wash relay, an isolated 4-20mA analog output configurable for pH or ORP, and an RS485 interface for data logging and remote control from a PC. The manual covers installation, front-panel operation, calibration procedures for pH and ORP modes, relay and analog output configuration, RS485 communication, error troubleshooting, and specifications.

What's inside

  • INITIAL INSPECTION and ASSEMBLY
  • GENERAL INTRODUCTION
  • USING THE JENCO MODEL 6311
  • MODEL 6311 MODES
  • CONTROLLING THE RELAYS
  • 4-20 mA OUTPUT
  • RS485 INTERFACE OPERATION
  • ERROR DISPLAYS AND TROUBLESHOOTING
  • pH BUFFERS
  • SPECIFICATIONS

Specifications

Power supply115 or 230VAC 50/60 Hz
Power consumption6 watts
Relay contact rating5 A at 115 VAC, 2.5 A at 230 VAC
4-20mA output load impedance< 500 Ohms
EnclosureWatertight ¼ DIN case
Excitation voltage output+5VDC and -5VDC, max 20mA each

Frequently asked questions

What are the relay contact ratings for the Model 6311?

The control relays are rated for 5 A at 115 VAC and 2.5 A at 230 VAC.

How do I calibrate the pH electrode on the Model 6311?

Enter calibration mode, select temperature probe, choose pH buffer standards, perform stand (buffer 1) and slope (buffer 2) calibrations, then set 4mA and 20mA outputs.

Download PDF (834 KB)

More JENCO Manuals


View all JENCO manuals →