This document is the installation and operation manual for HHPlus Series Pumps (Models PHP & PHPU). The pump must be installed and serviced by a professional service technician qualified in pool/spa installation. The procedures in this manual must be followed exactly to avoid dangerous electrical hazards. Improper installation and operation can cause high voltages to run through the electrical system, potentially resulting in death, serious injury, or property damage. This manual contains important information about the installation, operation, and safe use of the product, which should be given to the owner/operator of the equipment. It covers pump preparation and location, piping design and installation, electrical verification and installation, start-up, use and maintenance, troubleshooting, and specialty service such as removing blocked impeller.
The document serves as an installation and operation guide for the Jandy HHPlus Series pool pumps, specifically models PHP and PHPU. It emphasizes safety precautions regarding high-voltage electrical hazards and mandates that installation be performed by a qualified professional in accordance with local codes.
Key sections cover pump preparation, location requirements to minimize vibration and ensure proper ventilation, and detailed piping design specifications for suction and discharge lines based on horsepower ratings. The guide also includes instructions for electrical verification, bonding the motor to the pool structure, start-up procedures, general maintenance, winterizing steps, and troubleshooting common issues like blocked impellers or mechanical seal failures.
| Recommended Suction Pipe Size (1/2 to 1 HP) | 2" |
|---|---|
| Recommended Discharge Pipe Size (1/4 to 2 HP) | 2" |
| Recommended Suction Pipe Size (3 HP) | 3" |
| Motor Bonding Conductor | No. 8 AWG or larger |
This product must be installed and serviced by a professional service technician qualified in pool/spa installation.
No. Running the pump dry for any length of time will cause severe damage and void the warranty.
Pressure testing must not exceed 35 PSI.