Jandy ePump H0311300 Variable Speed Pump Controller Installation Manual

About this manual

This manual provides installation instructions for the ePump™ Variable Speed Pump Controller, model H0311300. It is intended for use with the Jandy ePump variable speed pump and covers safety instructions, installation procedures, and user operation.

What's inside

• Important Safety Instructions
• Installation of the ePump Controller
• User Operation
• Service Setup Options
• User Set Up Options
• Menu Flow Chart

Frequently asked questions

Who is qualified to install this product?

This product must be installed and serviced by a contractor who is licensed and qualified in pool equipment, or if no such requirement exists, by a professional with sufficient experience in pool equipment installation.

What is the maximum water pressure allowed for the system?

The system must not be connected to a source producing pressures greater than 35 PSI.

What is the maximum temperature allowed for a pressure test?

The water temperature for any test must not exceed 100°F (38°C).