Connecting Blackfin Processors to the AD7656 SAR ADC EE-Note

This is a technical note that describes how to connect Blackfin® processors to the AD7656 SAR ADC.


Connecting Blackfin Processors to the AD7656 SAR ADC EE-Note - cover page
Brand
Analog Devices
Category
Other Electronics
Document type
Application Note
Language
English
Pages
8
File format
PDF
File size
176 KB
Published
03 August, 2012
Updated
01 October, 2023
Model
AD7656
MD5 checksum
B0E88012732F1E842C1F8D4F581AFB6B

About this manual

This document details the process for developing hardware and software to interface an ADSP-BF5xx Blackfin processor with the AD7656 SAR ADC. It specifically uses the ADSP-BF537 EZ-KIT Lite evaluation system and the AD7656 Evaluation Module (EVM) as a demonstration platform.

The guide covers necessary hardware modifications to the EVM, such as replacing the bus transceiver for voltage compatibility and configuring jumpers for software mode operation. It also describes the Custom Interface Board (CIB) used to connect the processor to the ADC via the asynchronous external memory interface.

What's inside

  • Introduction
  • AD7656 Evaluation Module
  • Hardware Modifications
  • Custom Interface Board
  • System Software Functions
  • Modes of Operation
  • ONE_SHOT Mode
  • BLOCK_MODE
  • Appendix A: System Software Function Descriptions

Specifications

Processor ModelADSP-BF537
ADC ModelAD7656 SAR ADC
Development ToolsVisualDSP++ 4.5
System Clock Rate100 MHz
Core Clock Rate500 MHz

Frequently asked questions

What does BLOCK_MODE do?

It acquires a block of 256 words from each channel (totaling 1536 words) using 256 DMA transfers before triggering an FFT.

What hardware modifications are required to enable software mode on the AD7656 EVM?

The bus transceiver U2 must be replaced with a 3.3V part, and pin 24 of U2 must be disconnected from Vdrive and connected to a buffered /WR signal.

How many times does the BUSY signal transition during BLOCK_MODE operation?

The BUSY signal transitions 256 times to read a block of 256 words from each of the six AD7656 channels.

What sample rate is derived from the TMR3 output in the system software?

The TMR3 output serves as a time base for deriving a desired AD7656 sample rate of 61440 Hz.

Download PDF (176 KB)

More Analog Devices Manuals


View all Analog Devices manuals →