Yaskawa FS100 Error 88: File C1 through C3 for calibration between manipulators not set

Yaskawa FS100 · taken from the manufacturer’s manual, pages cited

Alarm code88

File C1 through C3 for calibration between manipulators not set The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”

Model
Yaskawa FS100
Display shows
88
Type
Alarm code
Source
Manual p. 195

What 88 means

File C1 through C3 for calibration between manipulators not set p. 195

Common causes

  • Software operation error occurred p. 195

What to do

  1. (1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 195

If 88 is still not resolved

  • (2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure). p. 195
    “(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and then contact your Yaskawa representative about occurrence status (operating procedure).”
Open the manual at page 195 All FS100 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 88; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.