MOTOWELD MEMORY ERROR7 means welding parameters may have failed to save due to power loss; reset the system, and if error persists, contact support for board issues. The manual's first action is: “Reset the system after saving the changed parameters. (See the manual of MOTOWELD "4.2.10 System Reset"). If the error occurs again, the board may be broken. Contact your Yaskawa representative.”
- Model
- Yaskawa 2DX200
- Display shows
- MOTOWELD MEMORY ERROR7 (4268)
- Type
- Error code
- Source
- Manual p. 62
What 4268 means
MOTOWELD MEMORY ERROR7 p. 62
Common causes
- The data may not have been correctly saved when the welding conditions are recorded because of a power failure, etc. p. 62
What to do
- Reset the system after saving the changed parameters. (See the manual of MOTOWELD "4.2.10 System Reset"). If the error occurs again, the board may be broken. Contact your Yaskawa representative. p. 62
Before you service the product, read the safety instructions in the manual p. 2.
If 4268 is still not resolved
- If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy. p. 2 “If your copy of the manual is damaged or lost, contact a YASKAWA representative to order a new copy.”
This page summarises what the manufacturer’s manual says about 4268; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Yaskawa. Found a mistake? Report an error.