Vacon 100 Flow Error 5: Charging switch

Vacon 100 Flow drive · taken from the manufacturer’s manual, pages cited

Fault code5

Charging switch fault occurs when the charging switch is closed but feedback information indicates it is OPEN. The manual's first action is: “Reset the fault and restart the drive. Do a check of the feedback signal and the cable connection between the control board and the power board. If the fault occurs again, ask instructions from the distributor near to you.”

Model
Vacon 100 Flow
Display shows
Charging switch (5)
Type
Fault code
Source
Manual p. 365

What 5 means

Charging switch p. 365

Common causes

  • The charging switch is closed and the feedback information is OPEN. p. 365

What to do

  1. Reset the fault and restart the drive. Do a check of the feedback signal and the cable connection between the control board and the power board. If the fault occurs again, ask instructions from the distributor near to you. p. 365

Before you service the product, read the safety instructions in the manual p. 88.

If 5 is still not resolved

  • contact your nearest service center or partner. p. 201
    “If the access code is lost, contact your nearest service center or partner.”
  • Go into the submenu Reset faults and use the parameter Reset Faults. p. 187
    “Go into the submenu Reset faults and use the parameter Reset Faults.”
Open the manual at page 365 All 100 Flow error codes Manual details & download

This page summarises what the manufacturer’s manual says about 5; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Vacon. Found a mistake? Report an error.