Vacon 100 Flow Error 361: Device changed (same type)

Vacon 100 Flow drive · taken from the manufacturer’s manual, pages cited

Fault code361

Device changed (same type) indicates that a new power unit of same size was installed and parameters are now available. The manual's first action is: “Reset the fault. The drive reboots after you reset the fault.”

Model
Vacon 100 Flow
Display shows
Device changed (same type) (361)
Type
Fault code
Source
Manual p. 373

What 361 means

Device changed (same type) p. 373

Common causes

  • The power unit was replaced by a new one that has the same size. The device is ready to be used. The parameters are available in the drive. p. 373

What to do

  1. Reset the fault. The drive reboots after you reset the fault. p. 373

Before you service the product, read the safety instructions in the manual p. 88.

If 361 is still not resolved

  • contact your nearest service center or partner. p. 201
    “If the access code is lost, contact your nearest service center or partner.”
  • Go into the submenu Reset faults and use the parameter Reset Faults. p. 187
    “Go into the submenu Reset faults and use the parameter Reset Faults.”
Open the manual at page 373 All 100 Flow error codes Manual details & download

This page summarises what the manufacturer’s manual says about 361; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Vacon. Found a mistake? Report an error.