Fault codeF7575
The motor encoder is not ready due to initialization failure or parking mode activation. The manual's first action is: “Evaluate other queued faults via motor encoder.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- Drive: Motor encoder not ready (F7575)
- Type
- Fault code
- Source
- Manual p. 297
What F7575 means
Drive: Motor encoder not ready p. 297
Common causes
- The motor encoder signals that it is not ready. p. 297
- Initialization of motor encoder was unsuccessful. p. 297
- The function "parking encoder" is active (encoder control word G1_STW.14 = 1). p. 297
What to do
- Evaluate other queued faults via motor encoder. p. 297
Before you service the product, read the safety instructions in the manual p. 2.
If F7575 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F7575; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.