Fault codeF7452
Following error exceeds tolerance limit, indicating significant deviation between setpoint and actual position. The manual's first action is: “Check the causes and resolve.”
- Model
- Siemens SINAMICS V90, SIMOTICS S-1FL6
- Display shows
- Following error too high (F7452)
- Type
- Fault code
- Source
- Manual p. 293
What F7452 means
Following error too high p. 293
Common causes
- The difference between the position setpoint and position actual value (following error dynamic model) is greater than the tolerance (p2546). p. 293
What to do
- Check the causes and resolve. p. 293
Before you service the product, read the safety instructions in the manual p. 2.
If F7452 is still not resolved
- Contact service / dealer for assistance p. 2 “Qualified Personnel The product/system described in this documentation may be operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions.”
- Contact service / dealer for assistance p. 13 “NOTICE Property damage due to loose power connections Insufficient tightening torques or vibration can result in loose power connections. This can result in damage due to fire, device defects or malfunctions.”
This page summarises what the manufacturer’s manual says about F7452; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.