Siemens G120C Error F07967: Drive: Incorrect pole position identification

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Fault codeF07967

An error occurred during the pole position identification routine, requiring a POWER ON reset for troubleshooting. The manual's first action is: “Only for internal Siemens troubleshooting. Carry out a POWER ON.”

Model
Siemens G120C
Display shows
Drive: Incorrect pole position identification (F07967)
Type
Fault code
Source
Manual p. 715

What F07967 means

Drive: Incorrect pole position identification p. 715

Common causes

  • A fault has occurred during the pole position identification routine. p. 715

What to do

  1. Only for internal Siemens troubleshooting. Carry out a POWER ON. p. 715

Before you service the product, read the safety instructions in the manual p. 4.

If F07967 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 715 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about F07967; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.