Siemens G120C Error F01044: CU: Descriptive data error

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Error codeF01044

An error was detected when loading descriptive data saved in non-volatile memory on the Siemens G120C. The manual's first action is: “Replace the memory card or Control Unit.”

Model
Siemens G120C
Display shows
CU: Descriptive data error (F01044)
Type
Error code
Source
Manual p. 668

What F01044 means

CU: Descriptive data error p. 668

Common causes

  • An error was detected when loading the descriptive data saved in the non-volatile memory. p. 668

What to do

  1. Replace the memory card or Control Unit. p. 668

Before you service the product, read the safety instructions in the manual p. 4.

If F01044 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 668 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about F01044; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.