Siemens G120C Error F01033: Units changeover: Reference parameter value invalid

Siemens G120C drive · taken from the manufacturer’s manual, pages cited

Error codeF01033

Error in parameterization/configuration/commissioning procedure for units changeover reference parameter value invalid on the Siemens G120C. The manual lists no action for this code.

Model
Siemens G120C
Display shows
Units changeover: Reference parameter value invalid (F01033)
Type
Error code
Source
Manual p. 663

What F01033 means

Units changeover: Reference parameter value invalid p. 663

Common causes

  • Error in the parameterization / configuration / commissioning procedure (18) p. 663

If F01033 is still not resolved

  • contact service / dealer p. 4
    “Warning concept This Manual contains information which you must observe to ensure your own personal safety as well as to avoid material damage.”
  • contact service / dealer p. 12
    “WARNING Danger to life if the safety instructions and residual risks are not observed”
Open the manual at page 663 All G120C error codes Manual details & download

This page summarises what the manufacturer’s manual says about F01033; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.