Siemens CU240B/E-2 Error F07080: Drive: Incorrect control parameter

Control unit · taken from the manufacturer’s manual, pages cited

Fault codeF07080

The closed-loop control parameters have been parameterized incorrectly. The manual lists no action for this code.

Model
Siemens CU240B/E-2
Display shows
Drive: Incorrect control parameter (F07080)
Type
Fault code
Source
Manual p. 691

What F07080 means

Drive: Incorrect control parameter p. 691

Common causes

  • The closed-loop control parameters have been parameterized incorrectly (e.g. p0356 = L_spread = 0). p. 691
  • Fault value (r0949, decimal interpretation): p. 691
  • The fault value includes the parameter number involved. p. 691
  • The following parameter numbers only occur as fault values for vector drives: p0310, for synchronous motors: p0341, p0344, p0357. p. 691
  • The following parameter numbers do not occur as fault values for synchronous motors: p0354, p0358, p0360. p. 691

If F07080 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Siemens service.

Open the manual at page 691 All CU240B/E-2 error codes Manual details & download

This page summarises what the manufacturer’s manual says about F07080; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.