Error codeERR284
The Board's configuration is incompatible with the MPU Controller board firmware level. The manual's first action is: “1) Install MPU firmware compatible with the Board configuration”
- Model
- Siemens 352P
- Display shows
- ERR284
- Type
- Error code
- Source
- Manual p. 263
What ERR284 means
Configuration on Board is not compatible with MPU Controller board firmware level. p. 263
What to do
- 1) Install MPU firmware compatible with the Board configuration p. 263
- 2) Press ENTER to ACK error. Controller will go on-line using configuration in MPU memory. The configuration will remain intact until a parameter is STOREd, at which time the MPU configuration will be transferred to the Board. p. 263
Before you service the product, read the safety instructions in the manual p. 11.
If ERR284 is still not resolved
- contact service / dealer p. 12 “Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes,”
- contact service / dealer p. 12 “the matter should be referred to one of the support groups listed in the Product Support section of this manual.”
This page summarises what the manufacturer’s manual says about ERR284; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.