Siemens 352P Error CYCLTIME: Cycle Time Overrun – see STATN block – add Cycle Time bias

Siemens 352P controller · taken from the manufacturer’s manual, pages cited

Error codeCYCLTIME

A Cycle Time Overrun occurred – see STATN block – add Cycle Time bias. The manual lists no action for this code.

Model
Siemens 352P
Display shows
Cycle Time Overrun – see STATN block – add Cycle Time bias (CYCLTIME)
Type
Error code
Source
Manual p. 264

What CYCLTIME means

Cycle Time Overrun – see STATN block – add Cycle Time bias p. 264

Common causes

  • Cycle Time Overrun – see STATN block – add Cycle Time bias p. 264

If CYCLTIME is still not resolved

  • contact service / dealer p. 12
    “Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes,”
  • contact service / dealer p. 12
    “the matter should be referred to one of the support groups listed in the Product Support section of this manual.”
Open the manual at page 264 All 352P error codes Manual details & download

This page summarises what the manufacturer’s manual says about CYCLTIME; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.