Error codeERR282
The Board's configuration failed a checksum test and is corrupted. The manual's first action is: “1) Power down and install a Board containing a valid configuration.”
- Model
- Siemens 352P
- Display shows
- ERR282
- Type
- Error code
- Source
- Manual p. 263
What ERR282 means
Configuration on Board failed checksum test and is corrupted. p. 263
What to do
- 1) Power down and install a Board containing a valid configuration. p. 263
- 2) Press ENTER to ACK error. Controller will go on-line using configuration in MPU memory that will also be loaded into the Board. p. 263
Before you service the product, read the safety instructions in the manual p. 11.
If ERR282 is still not resolved
- contact service / dealer p. 12 “Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes,”
- contact service / dealer p. 12 “the matter should be referred to one of the support groups listed in the Product Support section of this manual.”
This page summarises what the manufacturer’s manual says about ERR282; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.