Sanyo Machine Works SDNR Error EA: RECONFIGURATION ERROR

AC Servo Nutrunner · taken from the manufacturer’s manual, pages cited

Error codeEA

RECONFIGURATION ERROR occurs when power was interrupted or RS485 cables are damaged due to noise or improper connection. The manual's first action is: “Check the power source of DRIVER and DISPLAY PANEL.”

Model
Sanyo Machine Works SDNR
Display shows
RECONFIGURATION ERROR (EA)
Type
Error code
Source
Manual p. 109

What EA means

RECONFIGURATION ERROR p. 143

Common causes

  • The power to the DISPLAY PANEL or DRIVER was interrupted. p. 143
  • RS485 cable or its connection is wrong. p. 143
  • The aberration of the RS485 cable by noise etc. p. 143

What to do

  1. Check the power source of DRIVER and DISPLAY PANEL. p. 143
  2. Check the connection of the RS485 cable. Replace the cable if the trouble still occurs. p. 143
  3. Inform us about the environment around the NUTRUNNER (power noise or another noise source, etc.). p. 143

Before you service the product, read the safety instructions in the manual p. 65.

If EA is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Sanyo Machine Works service.

Open the manual at page 109 All SDNR error codes Manual details & download

This page summarises what the manufacturer’s manual says about EA; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Sanyo Machine Works. Found a mistake? Report an error.