Sanyo Machine Works SDNR Error E8: TOKEN ERROR

AC Servo Nutrunner · taken from the manufacturer’s manual, pages cited

Error codeE8

TOKEN ERROR occurs due to wrong RS485 cable connection or power not supplied to the DRIVER. The manual's first action is: “Check the connection of RS485 cables. Replace the cable if the trouble occurs after confirming the connection.”

Model
Sanyo Machine Works SDNR
Display shows
TOKEN ERROR (E8)
Type
Error code
Source
Manual p. 109

What E8 means

TOKEN ERROR p. 143

Common causes

  • RS485 cable or its connection is wrong. p. 143
  • The power is not supplied to the DRIVER. p. 143

What to do

  1. Check the connection of RS485 cables. Replace the cable if the trouble occurs after confirming the connection. p. 143
  2. Supply the power to the DRIVER. p. 143

Before you service the product, read the safety instructions in the manual p. 65.

If E8 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Sanyo Machine Works service.

Open the manual at page 109 All SDNR error codes Manual details & download

This page summarises what the manufacturer’s manual says about E8; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Sanyo Machine Works. Found a mistake? Report an error.