Rockwell Automation MicroLogix 1400 Error DCH: Class 3 CIP connections are duplicated for the same IP address.

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codeDCH

Class 3 CIP connections are duplicated for the same IP address indicates multiple identical network connections have been established on the same device or IP, causing conflicts. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
DCH
Type
Error code
Source
Manual p. 311

What DCH means

Class 3 CIP connections are duplicated for the same IP address. p. 311

Common causes

  • Class 3 CIP connections are duplicated for the same IP address. p. 311

If DCH is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about DCH; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.