Rockwell Automation MicroLogix 1400 Error D7H: Connection refused by destination host.

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codeD7H

Connection refused by destination host means the target device explicitly declined the connection request, possibly due to security or configuration restrictions. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Connection refused by destination host. (D7H)
Type
Error code
Source
Manual p. 311

What D7H means

Connection refused by destination host. p. 311

Common causes

  • Connection refused by destination host. p. 311

If D7H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about D7H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.