Rockwell Automation MicroLogix 1400 Error DFH: Multi-hop messaging has no IP address configured for network.

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codeDFH

Multi-hop messaging has no IP address configured for network means multi-hop communication cannot proceed because required network addressing information is missing or improperly set up. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
DFH
Type
Error code
Source
Manual p. 311

What DFH means

Multi-hop messaging has no IP address configured for network. p. 311

Common causes

  • Multi-hop messaging has no IP address configured for network. p. 311

If DFH is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about DFH; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.