Rockwell Automation MicroLogix 1400 Error D8H: Connection was broken.

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codeD8H

Connection was broken indicates a sudden loss of communication link between devices, often caused by network instability or hardware failure. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Connection was broken. (D8H)
Type
Error code
Source
Manual p. 311

What D8H means

Connection was broken. p. 311

Common causes

  • Connection was broken. p. 311

If D8H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about D8H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.