Rockwell Automation MicroLogix 1400 Error 16H

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code16H

Target or Local Bridge address is higher than maximum node address indicates an address exceeds the system’s maximum allowable limit. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
16H
Type
Error code
Source
Manual p. 310

What 16H means

Target or Local Bridge address is higher than the maximum node address. p. 310

Common causes

  • Target or Local Bridge address is higher than the maximum node address. p. 310

If 16H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 16H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.