Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The number of lines exceed the maximum value. The manual's first action is: “Delete redundant lines.”
In program editing, power is off. Please edit the program again. The manual's first action is: “Press reset key to cancel the alarm, and edit the program again.”
The parameter switch is turned ON. The manual's first action is: “Set parameter switch to the state of “OFF” (In MDI mode, press character “W” on the setting page), or press reset key.”
NC program and customer macro program exist simultaneously. The manual's first action is: “Modify the program. See programming manual for details.”
Macro code alarm does not exist. The manual's first action is: “Specify the correct macro code alarm number.”
The specified program number or sequence number has not been found in subprogram call. The manual's first action is: “Modify the program, and check the program number or sequence number specified by P.”
Subprogram calls too many nests. The manual's first action is: “Called subprograms exceed the limit. Subprogram is a four-embedded program. Modify the program nest structure.”
In the block M98, P is not specified. The manual's first action is: “Modify the program, and specify the correct P code.”
The program number is out of the range of 0001-9999. The manual's first action is: “Modify the program.”
The P or Q value of G70 is specified repeatedly. The manual's first action is: “Modify the program. See programming manual for details.”
M98,M99 or M30 is specified in blocks addressed by P or Q. The manual's first action is: “Modify the program and delete incorrect codes.”
In code G70, G71,G72,G73, in the blocks specified by P or Q, non-moving G Code or unusable G code is specified. The manual's first action is: “Modify the program. See programming manual for details.”
Error 065 occurs when G00 or G01 is not defined in the first block of a cycle, or when X/U or Z/W are not separately defined. The manual's first action is: “In the first block of NS~NF should be G00 or G01. In the fir…
Tool compensation cannot be used while executing certain G codes. The manual's first action is: “The above G codes can not be performed in tool compensation state. Execute G40 first.”
In G70, blocks specified by P or Q can not be found. The manual's first action is: “Modify the program, and add correct blocks.”