Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The program has an invalid cutting depth or negative value in a tool path command. The manual's first action is: “Modify the program. See programming manual.”
The finishing allowance is set to a negative value. The manual's first action is: “Range of finishing allowance: 0-9999.999 mm. Modify the program.”
#I or #K in G74 or G75 is a negative value. The manual's first action is: “Modify the program. See programming manual for details.”
053 on the GSK GSK980TB3 is listed in the manual as: P or Q value is not specified in G70,G71,G72,G73 code.. The manual's first action is: “Modify the program. See programming manual for details.”
Thread height or initial cutting depth specified in G76 is 0 or negative number. The manual's first action is: “Modify the program. See programming manual for details.”
In G76, minimum specified cutting depth or finishing allowance is bigger than thread height. The manual's first action is: “Modify the program, and specify a correct cutting depth. See programming manual for details.”
An unusable tool nose angle is specified in G76. The manual's first action is: “Modify the program, and specify a correct degree. See programming manual for details.”
Spindle CW (rotates negatively) is specified before stopping spindle CCW (rotates positively). The manual's first action is: “Perform M05, an then execute M03 or M04.”
Storage is wrong at power off. Please power on the CNC. The manual's first action is: “Cancel the alarm by pressing reset key, and power on again.”
The chuck releases when the spindle runs. The manual lists no action for this code.
The spindle will not start if the chuck is not clamped. The manual lists no action for this code.
Data input exceeds the allowable range. The manual's first action is: “Modify data or check whether the destination address value exceeds the range.”
In the process of tool nose radius compensation, G code is specified repeatedly in circular arc command. The manual's first action is: “Modify the program. See programming manual for details.”
Excessive cutting will occur in tool nose radius compensation The manual's first action is: “Check the program. See programming manual for details.”
Illegal command appears in the process of tool compensation. The manual's first action is: “Check the program. See programming manual for details.”