Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
RTU CHECK FAILURE indicates a CRC check error or encoder failure/connection problem The manual's first action is: “1. Check the motor's encoder connections. 2. Check the encoder if short circuit, poor solder joints or…
A slave device has failed due to an unrecoverable error or circuit overload. The manual's first action is: “1. Check connection of the motor cable (U,V,W) and encoder. Check power cable connection. Refer to the diagra…
The drive has detected an illegal data value or exceeded its rated load during continuous operation. The manual's first action is: “1. Check connection for Motor terminal s (U,V,W) and Encoder. 2. Adjust the Drive gai…
The data address received in the query is not an allowable address for the server (or slave). The manual's first action is: “1. Use multi-meter to check whether the input voltage is within the specified limit. 2. Chec…
The drive received an illegal function command or the input voltage is below 190Vac. The manual's first action is: “Use multi-meter to check whether the input voltage is within the specified limit. If it can not be so…
AL-11 indicates a position error when the value exceeds preset pulse limits. The manual's first action is: “an Alarm message AL-11(Position error value alarm) will be displayed.”
Input terminals CCWL and CWL are activated simultaneously. The manual's first action is: “Set the parameter Cn002.1=1 to disable the drive limit function temporarily during trial run period.”
All 18 error codes of the TED TSTE Series TED TSTE Series with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The received data exceeds the range that the balance can accept. The manual's first action is: “Confirm the parameter range of the command.”
The system detected incorrect data in a command. The manual's first action is: “Confirm the command.”
The balance received excessive characters in a command. The manual's first action is: “Confirm the command.”
The system timed out waiting for a response from the balance. The manual's first action is: “Confirm the communication.”
The value entered is beyond the settable range. The manual's first action is: “Re-enter the value.”
The balance has detected an overload condition. The manual's first action is: “Remove the sample from the pan.”
The calibration weight is too light. The manual's first action is: “Confirm the calibration weight value.”