Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The Gefran TPD32-EV experienced undervoltage conditions. The manual lists no action for this code.
The Gefran TPD32-EV detected an overcurrent condition. The manual lists no action for this code.
The Gefran TPD32-EV encountered an unknown error code. The manual lists no action for this code.
All 18 error codes of the Gefran TPD32-EV TPD32-EV drive with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
1. The servo is turned ON or the power supply is turned ON near the machine home position or in the zone in which addresses decrease., 2. The machine falls on a vertical axis when the servo-on (SON) is turned ON/OFF. …
1. Wiring for the ABS data signal (ABS bit 0 (PF), bit 1 (ZSP)) is disconnected or connected to the SG terminal., 2. PC ladder program wrong., 3. Faulty PLC input module. The manual's first action is: “Correct the wir…
Data No. not existing in the specifications was transmitted. The manual lists no action for this code.
Command not existing in the specifications was transmitted. The manual lists no action for this code.
Character not existing in the specifications was transmitted. The manual lists no action for this code.
Checksum error occurred in the transmitted data. The manual lists no action for this code.
Parity error occurred in the transmitted data. The manual lists no action for this code.
Normal operation indicates that transmitted data was processed properly. The manual lists no action for this code.
ABS servo-on warning occurs with no specified cause listed. The manual's first action is: “Power OFF→ON”
Main circuit off warning occurs if servo-on was switched on while main power was off. The manual's first action is: “Power OFF→ON”
Servo emergency stop warning occurs when EMG is off. The manual's first action is: “Power OFF→ON”