Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The system failed to add a channel diagnostic entry into the PROFINET IO stack. The manual lists no action for this code.
The subslot number provided is outside the valid range for this device. The manual lists no action for this code.
The slot number provided is outside the valid range for this device. The manual lists no action for this code.
The system detected that no submodule was inserted into the specified subslot. The manual lists no action for this code.
No module is inserted in the specified slot on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.
The API does not exist on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.
An unknown error occurred with a code between 17 and 255 on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.
The segmentation buffer overflowed on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.
A segmentation failure occurred because the socket has already been shut down on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.
Resources are out of range because a destination address is required on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.
The current state is invalid due to an error in the pipe on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.
A value is out of range because the message size is invalid on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.
There is not enough data in the message data field because the service data is invalid on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.
There is too much data in the message data field because the socket is already in the requested mode on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.
Attribute access is not get-able because the socket is not connected on the HMS Industrial Networks Anybus CompactCom PROFINET IO. The manual lists no action for this code.