Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The input relay is faulty and needs replacement or repair. The manual's first action is: “Switch off and disconnect the UPS from the power supply and contact the support centre.”
The input relay is faulty and needs replacement or repair. The manual's first action is: “Switch off and disconnect the UPS from the power supply and contact the support centre.”
The input relay is faulty and needs replacement or repair. The manual's first action is: “Switch off and disconnect the UPS from the power supply and contact the support centre.”
The UPS temperature is below 0°C due to Sensor2 reading too low. The manual's first action is: “Check the temperature of the environment in which the UPS is located; if it is too low, bring it past the minimum thresho…
The UPS temperature is below 0°C due to Sensor1 reading too low. The manual's first action is: “Check the temperature of the environment in which the UPS is located; if it is too low, bring it past the minimum thresho…
All 30 error codes of the Riello Sentinel Dual Riello Sentinel Dual UPS with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The device displays "LY" indicating a possible issue with power cord connection or conduction. The manual's first action is: “Check the connection and conduction of the power cord.”
A measuring unit without a reference point is connected, or the reference point signal wire is broken. The manual's first action is: “Connect a measuring unit with a reference point. If this does not correct the probl…
Stored data has been altered due to noise or interference; restart settings from basic configuration. The manual's first action is: “If this error is displayed frequently, the memory may be damaged. Contact your vendor.”
The display has overflowed, indicated by an "F" added to the highest digit. The manual's first action is: “Use in a range where an "F" is not added.”
The measuring unit is not connected to the device. The manual's first action is: “Turn off the power, connect the measuring unit, and then turn on the power again. The display value is reset to zero.”
All 5 error codes of the Magnescale LY72 Magnescale LY72 with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Command aborted occurs when a blocking command is interrupted because the socket it was waiting on has been closed using the Delete command. The manual lists no action for this code.
ETOOMANYREFS means there are too many references. The manual lists no action for this code.
A service or operation is already in progress and cannot be started again. The manual lists no action for this code.