Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The calibration data storage is full while saving data in cal mode. The manual lists no action for this code.
Calibration data is invalid on initialization or the unit was never calibrated. The manual lists no action for this code.
There is a secondary SPI communication error during initialization. The manual lists no action for this code.
A ROM checksum failure has occurred. The manual lists no action for this code.
The RAM test has failed. The manual lists no action for this code.
There is a time base failure. The manual lists no action for this code.
NIBP PT2 is higher than 150 for more than 15 seconds while idle. The manual lists no action for this code.
The NIBP valve is stuck closed during cuff typing. The manual lists no action for this code.
950 indicates the NIBP pump is running during idle or an overcurrent condition was detected. The manual lists no action for this code.
940 means fewer than 45 temperature data samples were collected in a 5-second interval. The manual lists no action for this code.
930 indicates no status from the SpO2 module for 30 ±10 seconds, a fatal error reported by the module. The manual lists no action for this code.
E13 means the battery level is too low to operate the device. The manual lists no action for this code.
E12 indicates the battery level is too low to print. The manual lists no action for this code.
E11 shows the printer is too hot to operate. The manual lists no action for this code.
E10 means there is no paper in the printer. The manual lists no action for this code.