Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
An error occurred while writing during RUN mode; set CPU to STOP and re-write project data. The manual's first action is: “Set the CPU module to STOP and write a set of project data.”
The number of times an applied instruction has been used exceeds the program’s specified limit and must be reduced. The manual's first action is: “Verify that the number of times that applied instructions are used in …
A communication or I/O channel is already in use by another instruction and needs verification. The manual's first action is: “Verify that the channel specified by instructions using communication functions or built-i…
Duplicate IP addresses were detected, indicating a conflict in network configuration. The manual's first action is: “Check the IP address.”
A preset value is outside the allowed range and must be corrected. The manual lists no action for this code.
The high-speed comparison table has exceeded its maximum capacity and needs adjustment. The manual lists no action for this code.
A pointer execution error occurred and requires further investigation. The manual lists no action for this code.
A file name specification error occurred with no cause listed in the manual. The manual lists no action for this code.
A module specification error occurred, but no details are provided in the manual. The manual lists no action for this code.
An invalid interrupt was detected and requires further investigation. The manual lists no action for this code.
A module verification error occurred with no specific cause listed in the manual. The manual lists no action for this code.
Write and clear requests (MB492 and SM8495) were activated simultaneously, which is not permitted. The manual's first action is: “Verify that write request and clear request (SM8492 and MS8495) do not turn from OFF to…
IP address settings (SD8492 to SD8497) are outside their allowed range and must be rechecked. The manual's first action is: “Recheck the values such as the IP address setting (SD8492 to SD8497).”
The scan time has exceeded the configured constant scan time value and needs correction. The manual's first action is: “Check and correct the constant scan time setting. Recheck the setting time of the constant scan.”
A low battery voltage was detected along with a latched device error; check or replace the battery. The manual's first action is: “Check the connection of the battery; Replace the battery as soon as possible.”