Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The control senses an entering load side water temperature of 54.4°C regardless of mode. The manual's first action is: “Compressor operation will be disabled.”
The control voltage drops below 18VAC for 10-15 continuous seconds. The manual's first action is: “All operation will be disabled.”
The control detects the freeze detection probe is open or has infinite resistance. The manual's first action is: “Compressor and pump operation will be disabled.”
The control detects the freeze detection probe is closed or has no resistance. The manual's first action is: “Compressor and pump operation will be disabled.”
The control detects the water temperature probe is open or has infinite resistance. The manual's first action is: “Compressor and pump operation will be disabled.”
The control detects the water temperature probe is closed or has no resistance. The manual's first action is: “Compressor and pump operation will be disabled.”
All 6 error codes of the WaterFurnace NSKW geothermal hydronic heat pump with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The boom section is positioned too high, the sensor’s zero height setting is incorrect, or the sensor is facing strong sonic targets like concrete. The manual's first action is: “Follow 4.2.4 a).”
The sensor is reading a target too close (less than 7 inches) or is contaminated, or moisture has entered the sensor. The manual's first action is: “Follow 4.2.3 a).”
A wiring issue has been detected, possibly due to a wrong or poor cable connection, defective cables, or an incorrect switch press on the sprayer's hand-control. The manual's first action is: “Follow 4.1.3 a.”
The system has detected that the hydraulic cylinder has reached its end of stroke while still attempting to move further in that direction, or the boom is moving too slowly or lacks sufficient hydraulic pressure. The …
All 4 error codes of the NORAC UC4 sprayer with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
NMEA data Void occurred because invalid data output was received. The manual lists no action for this code.
Measurement average building is in progress, warning that the average period was not reached during averaging (only applicable to non-heat enabled units). The manual lists no action for this code.
ROM error occurred because the ROM checksum failed, indicating data might be uncalibrated. The manual lists no action for this code.